2. 考研
  3. 【C1】______. That fact that an airplane is up in the air and cannot stop if anything goes wrong makes it perhaps a matter of life

【C1】______. That fact that an airplane is up in the air and cannot stop if anything goes wrong makes it perhaps a matter of life

admin2019-06-26  35
问题     【C1】______. That fact that an airplane is up in the air and cannot stop if anything goes wrong makes it perhaps a matter of life or death that its performance is absolutely dependable.
    【C2】______ . Out of that weight as much as possible is wanted for fuel, radio instruments, passenger seats or freight room, and, of course, the passengers or freight themselves. So the structure of the aircraft has to be as small and light as safety and efficiency will allow. The designer must calculate the normal load that each part will bear. This specialist is called the "stress man". He takes account of any unusual stress that may be put on the part as a precaution against errors in manufacture, accidental damage, etc.
    This stress man’s calculations go to the designer of the part, and he must make it as strong as the stress man says. One or two samples are always tested to prove that they are as strong as the designer intended. Each separate part is tested, then a whole assembly—for example, a complete wing, and finally the whole airplane. When a new type of airplane is being made, normally only one of the first three made will be flown. Two will be destroyed on the ground in structural tests. The third will be tested in the air.
    【C3】______. The first is to find the resistance to loading of the wings, tail, etc. until they reach their maximum load and collapse. The other test is for fatigue strength. Relatively small loads are applied thousands of times. Each may be well under what the structure could stand as a single load, but many repetitions can result in collapse. One form of this test is done on the passenger cabin. It is filled with air at high pressure as for high altitude flying and completely submerged in a large tank of water while the test is going on. The surrounding water prevents the cabin from bursting like a bomb if there is a failure.
    【C4】______.
    Making the working parts reliable is as difficult as making the structure strong enough. The flying controls, the electrical equipment, etc. must not only be light in weight, but must work both at high altitudes where the temperature may be below the freezing point and in the hot air of an airfield in the tropics.
    【C5】______.
[A] Two kinds of ground strength tests are carried out.
[B] To solve all these problems the aircraft industry has a large number of research workers, with superior laboratories and test houses; and new materials to give the best strength in relation to weight are constantly being tested.
[C] It is easy for a plane to pass all the tests in order to fly legally.
[D] There are two main things that make aircraft engineering difficult: the need to make every component as reliable as possible and the need to build everything as light as possible.
[E] When a plane has passed all the tests it can get a government certificate of airworthiness, without which it cannot be legally flown, except for test flying.
[F] Given a certain power of engine, and consequently a certain fuel consumption, there is a practical limit to the total weight of aircraft that can be made to fly.
[G] The structure of the aircraft has to be as small and light as possible.
【C1】
选项
答案D
解析 由语篇结构知识可知，作者往往在文章开始提出问题。而由文章其余段落可发现重复出现的词汇：reliable，light，weight等，这些词汇表明了文章的中心思想：关于飞机测试要解决的两个主要问题为其可靠性和重量。这正是[D]的内容。
转载请注明原文地址:https://www.kaotiyun.com/show/v19Z777K
0

考研英语一

相关试题推荐
随机试题
最新回复(0)