2. 计算机
  3. Which encapsulation types are configurable on a Cisco switch for a trunk? (Select two answer choices) A. VTP B. ISL C. CDP D. 80

Which encapsulation types are configurable on a Cisco switch for a trunk? (Select two answer choices) A. VTP B. ISL C. CDP D. 80

admin2009-05-19  29
问题 Which encapsulation types are configurable on a Cisco switch for a trunk? (Select two answer choices)
A. VTP
B. ISL
C. CDP
D. 802.1Q
E. 802.1p
F. LLC
G. IETF
选项
答案B,D
解析 Explanation:
Trunks are used to carry traffic belonging to multiple VLANs between devices over the same link. A device can determine which VLAN the traffic belongs to by its VLAN identifier. The VLAN identifier is a tag that is encapsulated with the data. ISL and 802.1q are two types of encapsulations used to carry data from multiple VLANs over trunk links.

ISL is a Cisco proprietary protocol for interconnecting multiple switches and maintaining VLAN information as traffic goes between switches. ISL provides VLAN trunking capabilities while maintaining full wire speed performance on Ethernet links in full-duplex or half-duplex mode. ISL operates in a point-to-point environment and will support up to 1000 VLANs.

In ISL, the original frame is encapsulated and an additional header is added before the frame is carried over a trunk link. At the receiving end, the header is removed and the frame is forwarded to the assigned VLAN. .ISL uses Per VLAN Spanning Tree (PVST) which runs one instance of Spanning Tree Protocol (STP) per VLAN.

PVST allows for optimal root switch placement for each VLAN and supports load balancing of VLANs over multiple trunk links. 802.1Q is the IEEE standard for tagging frames on a trunk and supports up to 4096 VLANs. In 802.1Q, the trunking device inserts a four-byte tag into the original frame and re-computes the Frame Check Sequence (FCS) before sending the frame over the trunk link. At the receiving end, the tag is removed and the frame is forwarded to the assigned VLAN. 802.1Q does not tag frames on the native VLAN.

It tags all other frames transmitted and received on the trunk. While configuring a 802.1 trunk, you must make sure that the same native VLAN is configured on both sides of the trunk. IEEE 802.1Q defines a single instance of spanning tree running on the native VLAN for all the VLANs in the network which is called Mono Spanning Tree (MST). This lacks the flexibility and load balancing capability of PVST available with ISL. However, PVST+ offers the capability to retain multiple Spanning Tree topologies with 802.1Q trunking.
转载请注明原文地址:https://www.kaotiyun.com/show/9ShZ777K
本试题收录于： 思科640802题库思科认证分类
0

思科640802

思科认证

相关试题推荐
随机试题
最新回复(0)